Design to BS 8110

Beam Design for Torsion | Worked Example

The method of beam design for torsion with worked example is debussed in this article.…

Under Reinforced Section Design

Becoming section under reinforced section than over reinforced section is good in structural design. Under…

How to Check Section is Over Reinforced

The over-reinforced section is considered critical when compared with the under-reinforced condition. If over-reinforced, the…

Concrete Beam [design and detailing]

The concrete beam is one of the basic elements in a structure. Concrete columns and…

Punching Shear Design a Detailed Discussion

Punching shear is a failure mechanism when structural elements subjected to concentrated load. Failure occurs…

Cover to Reinforcement as per BS 8110

Cover to reinforcement is a key factor taken into account in the design and construction.…

Beam Design to BS 8110

Singly Reinforced Section design Beam design can be done for different codes depending on specific…

Slab Design to BS 8110

Slab design is comparatively easy when compared with the design of other elements. The first…

Shear Design of Beam

Design for shear is one vital thing to look at when designing structural elements. Cracks…

Punching Shear Perimeter

Punching shear around the columns, piles, etc. It usually checked in footings, raft foundations, pile…

Design Strength BS 8110

Design strength for BS 8110 The design strength of material for different cases is tabulated…

Doubly Reinforced Beam Design to BS 8110

According to BS 8110, the concrete strain is limited to 0.0035 and the yielding of…

This website uses cookies.